When you need truly industrial inkjet coders, Chinahae is ready with the right products and technical service for your application. A Lot Coder, Batch Coder or Date Coder from Superior always offers the greatest dependability and value on the market.
For your Date Coding needs, Chinahae delivers rock-bottom pricing on only the most advanced, low maintenance industrial inkjet coders. We are always ready to serve you with all the support you need for your application.
We have DOD, CIJ, TIJ different type Inkjet printers, high resolution inkjet coder can be used in food, beverage, building material, pipe, cable, pharmaceutical, electronic etc. field
Inkjet Coding Printer,Industrial Inkjet Printer,Continuous Inkjet Printer,Handheld Inkjet Printer,Date Coding Printer,Inkjet Coder Machine,Inkjet Coding Systems,Inkjet Code Printer,Inkjet Date Code Printer Wuhan HAE Technology Co., Ltd. , https://www.whwallprinter.com
First, after the use of inspection steps 1, check the power take-off control switch is returned, check the throttle controller is the minimum position.
2, check the valve handle position, are closed.
3, close the control box door.
Second, what to do before use to prepare 4, the conductive rod into the ground to make it "grounded", if the ground is dry, you can boil the water to make it wet, to ensure good grounding. Check the ground to make contact with the ground.
1. Check the lubricant oil level in the gearbox to the lower edge of the oil surface screw hole. If insufficient, add gear oil.
2. Check the transmission control lever to make it in the neutral position. Check the position of the power lever control handle to make it horizontally to the right position so that it is horizontally to the right position. Check the throttle controller so that it is the minimum.
3. Whether the operating rods and valves in the fuel tank are in friction with the ground during use.
4. When the oil pump is used for the first time, when there is no oil in the pump, it should be refueled in advance and 10 liters can be added through the oil inlet.
Third, the power take-off and the pump between the operating instructions 1, start the connection to the relevant pipeline, start the engine, when the original car pressure gauge reading reaches 0.3Mpa, step on the clutch pedal, open the power box control switch, slowly loosening Damage to the PTO and gearbox will soon be applied to make it stop.
Through the throttle controller, the working speed of the oil pump can be controlled.
2, stop the throttle controller to advance, adjust to the minimum, step on the clutch pedal, the power take-off control switch to return to the original position, so that the power take off box.
Safety hazard prevention and correct operation method of tanker
The basic concern of many small tanker drivers is the safety of the car. In fact, the safety of the tanker must not have any potential safety hazards. Usually, at work, we must remember to follow the safety instructions of the car. Therefore, ask the driver's friends to drive in the car. Before and after use, you must follow the rules to ensure that everything is safe.
Next Article
Water/Air Turbine Meter Low Cost Flow Meter